MCOSMOS CAT 1000PS

This course is run over two days. It covers the use and application of the software. It is expected that personnel attending the course will be fully conversant with GEOPAK, Probe Calibration and the establishment of Co-ordinate Systems.

The course is comprised of the following elements:

  • Introduction and start procedure
  • Machine Builder (v2.4 + v3.0 only)
  • CMM System Manager (v3.2 only)
  • Viewing the CAD model
  • CAT 1000 settings
  • Measurement of Geometric elements using the CAD model (i.e. Point, Plane, Circle, Line, Point, Cylinder, Cone and Sphere)
  • Move machine using the CAD model (CNC only)
  • Probe changes using the CAD model
  • Surface measurement (CAT1000S only)
  • Viewing measured Surface data (CAT1000S only)
  • Manipulation of measured Surface data (CAT1000S only)
  • Output and Storage of measured Surface data (CAT1000S only)
  • Best Fit
  • Reference Point System (R.P.S.) alignment
  • Alignment Wizard (v3.2 only)
  • Off-line programming and program simulation
contact_block.jpeg

Get in touch!

For support, to place an order or to make enquiries please call:

01264 353123
8.30am till 5pm - Monday to Friday


Send a Message

education_pack_block.jpeg

FREE Education Pack

Mitutoyo's Education Pack comprises a range of items designed to serve as convenient references to the theory and practice of engineering metrology for use in the classroom, workplace and laboratory.

Claim your FREE pack

services_block.jpeg

Our services

A complete solution - Mitutoyo is not only a vendor of top quality measuring products but one that also offers guaranteed support for the lifetime of the equipment, backed up by comprehensive services.

See our services

*Course length subject to variation depending on which route is taken